How to program BECKER VC420?
Set the VC420 to programming mode by switching on the power
supply:
1.
Switch on the power supply
2.
The VC420 will remain in the programming mode for 3 minutes
OR set the VC420 using the programming button:
1.
Press and hold the programming button for 3 seconds
2.
The VC420 will remain in the programming mode for 3 minutes
Programming the master transmitter:
NOTE
:
The master transmitter is the very first transmitter programmed on a receiver. It
enables the setting of limit positions (for drives with integrated radio receivers) and the
programming or deleting of further transmitters.
1.
Press the programming button of the transmitter for 3 seconds
2.
The system will confirm the program setting with a ‘nod’. i.e. the shutter/awning/blind
moves a few centimeters in one direction and then reverses the same distance
3.
The programming process is now complete
Visit our website : www.alloremotecontrol.com
