Allo E1/T1 PRI Card Quick Installation Guide
# dahdi_genconf
–
vvvvv
By running
"dahdi_genconf"
, it will generate /etc/dahdi/system.conf and etc/asterisk/dahdi-
channels.conf automatically. Check whether the generated files information agrees with your
hardware setup, if not, you should modify to your specific requirements.
Dahdi_genconf-vvv channels configure with Asterisk
Do not forget to
include”
dahdi-channels.conf
”
in
“
chan_dahdi.conf
”
to configure Dahdi
channels with asterisk, if not, run command:
# echo "#include dahdi-channels.conf" >> /etc/asterisk/chan_dahdi.conf
Execute the following command:
# dahdi_cfg
–
vvvvv
This command is used for the entire spans channels configuration.
To check dahdi hardware devices run the command “
dahdi_hardware
”
from the command
prompt a sample output is shown below.
After compiling and installing DAHDI and Asterisk, load the Dahdi driver by running:
Check alloPL4xxp show with + symbol “+ shows module loaded “
Start the Asterisk by executing
# asterisk -gvvvvvvvvvc
Make sure that PRI spans are up and active, before making calls. Here is the command to check
the PRI span status
CLI>pri show spans