5
•
"On-the-Fly" Triode/Pentode Switching. Switching between triode and pentode operation can be done "on-the-
fly" at any time while the amplifier is in use.
•
Beautiful 20KHz square wave response. See Figures 1-3.
Fig.1 Square Wave 50Hz*
Fig.2 Square Wave 1KHz*
Fig.3 Square Wave 20KHz*
*
Measured by LEADER LAG-126 Audio Signal Generator and
KENWOOD CS-4125
Oscilloscope.
•
As are all Allnic Audio products, the M-3000 MK II is fully RoHS (EU Reduction of Hazardous Substances
regulation) compliant in construction and materials.
WHAT’S IN THE BOX?
Please check that the pair (assuming you purchased a pair) of shipping boxes contain the following:
•
One (1) each Allnic M-3000 MK II monoblock power amplifier
•
One (1) each 15 amp IEC type power cord
•
One (1) Owner’s Manual
Note:
1)
The M-3000 MK II ships with the tubes installed.
2)
The M-3000 MK II will work with most IEC type aftermarket power cords. The Allnic ZL-3000 and ZL-
5000 power cables will make an excellent match. Of course, only you can determine the power cord
that works most synergistically with the M-3000 MK II in your system.
3)
Be sure the M-3000 MK II is labeled for the AC voltage of your location. If it is not, DO NOT connect
it to your AC outlet. Please contact your Allnic dealer.
We advise that you keep the boxes and other packing materials that your M-3000 MK II came in. It will be
useful if you sell your M-3000 MK II or in the unlikely event you need to ship it for service.
SAFETY
•
Remove ALL protective cushioning material (cardboard around the tubes) inside the tube chimneys
before operation. The tube chimneys should contain NOTHING except the tubes
(It is optional to
leave the “O” rings on the small tubes; some prefer the sound with the O rings on).
•
Disconnect the power cord by pulling the plug, not the cable.
•
Do not attempt any repairs. Do not remove the unit’s chassis cover without specific authorization from
Your Allnic dealer.
•
Keep the power cord away from heat sources
•
Keep the unit away from liquids – do not allow any liquid to enter the interior of the unit.
