Allmand Port-A-Lite PAL Single LED Series, Руководство оператора

Страница: 2 / 36

Not for
Reproduction
2
Products Covered by This
Manual
The following products are covered by this manual:
PAL50 Single LED, PAL60 Single LED
Manual Contents:
Introduction........................................................................... 2
Safety......................................................................................2
Features and Controls..........................................................5
Set-Up.....................................................................................6
Operation............................................................................... 6
Maintenance...........................................................................9
Troubleshooting....................................................................9
Specifications........................................................................9
Wiring Diagrams................................................................. 11
Introduction
About This Manual
TAKE TIME TO READ THIS MANUAL THOROUGHLY
This instruction manual provides necessary instructions
for the Allmand
®
PAL50 Single LED, PAL60 Single LED
Portable Work Light.
The information found in this manual is in effect at the time
of printing. Allmand Bros Inc. may change contents without
notice and without incurring obligation.
The images throughout this manual are representative, and
may differ from your model.
Any reference in this manual to left or right shall be
determined by looking at the trailer from the rear.
If uncertain about any of the information in the
manual, contact the Allmand service department at
1-800-562-1373, or contact us through the Allmand website,
www.allmand.com.
Save these original instructions for future reference.
Safety
Safety Definitions
For your safety, the safety of others, and to protect the
performance of equipment, follow the precautions listed
throughout the manual before operation, during operation and
during periodic maintenance procedures.
Indicates a potential personal injury hazard.
DANGER
Indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE
Information considered important but not hazard related.
Safety Precautions
The following section contains general safety precautions
and guidelines that must be followed to reduce risk to
personal safety. Special safety precautions are listed in
specific procedures. Read, understand and obey all of the
safety precautions before operating or performing repairs or
maintenance.
DANGER
Electrocution Hazard
• Always place the portable work light on a dry surface
and away from areas where water might flow or
accumulate.
• Do not stand on a wet surface or in water when
connecting the portable work light to a power source
such as a wall outlet or power generator, or when
operating the light switch.
• Always check for overhead wires or obstructions before
raising or lowering the mast.
• Always follow the rules or instructions for your work
site and state, province and national electric code for
maintaining a safe distance from overhead wires.
• High voltage is present when the unit is plugged into
a power source. Never attempt to service electrical
components while the portable work light is connected
to a power source.
• Do not operate the portable work light if the insulation
on the power cord or other electrical wiring is cut or
worn, or if bare wires are exposed. Repair or replace
damaged wiring before connecting to a power source.
WARNING
Unsafe Operation Hazard
• Never permit anyone to operate the equipment without
proper training.
• Read and understand this Operator’s Manual before
operating or servicing the work light to ensure that safe
operating practices and maintenance procedures are
followed.
• Safety signs and decals are additional reminders for
safe operating and maintenance techniques.