Allmand Maxi-Power MP65-8C1, Руководство оператора

Страница: 31 / 55

30 ALLMAND.COM
Check / Clean Air Filter Element
1. Loosen latch ( L ), and remove cap ( K ). Clean
interior of cap.
2. Remove and clean filter element ( M ). If damaged
or heavily soiled, replace. (For part numbers, see
Replacement Parts .)
3. Clean interior of case ( N ).
4. Install filter element into case, then install cap,
securing with latch.
M
N
K
L
Drain Fuel Tank
1. Remove the drain plug ( O ) and drain any condensate
accumulated inside the fuel tank ( P ) into an approved
container.
2. After making sure all condensate is drained, reinstall
the drain plug.
3. Dispose of condensate according to local, state and/or
federal regulations.
P
O
Battery Maintenance
WARNING
• Keep ignition sources away from battery.
• Battery generates hydrogen gas and may explode if
ignited.
• Charging should be done at a well-ventilated place.
• Do not spark near the battery nor light a match, nor
bring lit cigarette and match close to the battery.
• Do not check the battery by short-circuiting the
positive and negative terminals.
• Do not operate machine or charge battery with low
electrolyte level. Doing so may damage battery, or
may cause explosion.
• Add distilled water so that electrolyte level reads
between “UPPER” and “LOWER” level.
• Do not charge frozen battery. Otherwise it may
explode. If battery is frozen, warm it up until the
battery temperature becomes 16°C to 30°C.
• Battery electrolyte is dilute sulfuric acid.
• Mishandling battery could cause severe burns.
• Wear protective gloves and safety goggles when
handling battery.
• If battery electrolyte contacts clothes or skin, wash
immediately with large amount of water.
• If battery electrolyte gets into eyes, flush with plenty
of water and seek immediate medical attention.
• Dispose of battery according to local, state and/or
federal regulations.
Check Battery Electrolyte
Standard battery:
1. Check battery electrolyte level. If low, add distilled
water.
2. Measure specific gravity of battery electrolyte. If
below 1.24, recharge battery. See Charge Battery .
Maintenance-free battery:
1. Check indicator on top surface of battery.
2. If indicator shows that charge is needed, recharge
battery.
Charge Battery
1. Disconnect cables between battery and unit, black
negative (-) cable first, and charge battery ( A ) with
a 12-volt battery charger ( B ). Do not charge two
batteries at the same time.
2. Be sure not to connect (+) and (–) terminals
backwards.
3. Read operation manual of battery charger before
use.
Go to
Discount-Equipment.com
to
order your parts