Allied Vision Goldeye G, Техническое руководство

Страница: 56 / 136

50 Goldeye G Technical Manual V 2.0.0
Filters and mounts
To change the filter of the F ‐ Mount lens adapter, follow the instructions outlined
below.
1. Remove the lens that might be screwed into the F ‐ Mount adapter.
2. Unscrew the adapter (1) from the camera.
‐ Loosen the locking screw (2, shown from back of adapter) on the outside
of the mount adapter. See Figure 11 on page 46 for the position of the
locking screws.
Use a 0.9 mm hex key Goldeye G ‐ 008, G ‐ 032 and G ‐ 033,
use a 1.3 mm hex key Goldeye G ‐ 032 Cool.
‐ To avoid penetration of foreign substances into the camera, ensure that
the front flange is covered with a dust cap. See Avoiding the necessity of
camera cleaning on page 118 .
3. On the back side of the mount, loosen the three cylinder bolts (5) of the filter
fixing ring (4), using a Torx T6 tool.
4. Remove the fixing ring.
5. Remove the existing filter glass (3) from the adapter.
6. Insert the new filter glass into the matching recess.
‐ See Table 15 above (blue = filter, red = filter recess).
‐ See Table 18 above for dimensions of suitable filter glasses.
7. Reinsert the fixing ring into the adapter.
8. Fix the ring with the three cylinder bolts.
‐ Tighten the bolts with a max. torque of 0.25 Nm.
9. Screw the adapter into the camera again.
10. Tighten the locking screw with a max. torque of 0.1 Nm.
Figure 15: Changing the filter in the F‐Mount adapter
1
2
3
4
5