Installing the camera
61
Alvium USB Cameras User Guide V1.1.0
Mounting the camera
Mounting bare board cameras
Schematic drawings in
show Alvium USB bare board cameras. Only the
mounting area (gray) can be used for mounting. The sensor/electronics area (red)
must not be touched nor put at mechanical stress.
a = Screw hole
b = Screw hole and chassis ground
1. Mount the bare board with four M2 screws at 0.1 Nm maximum torque.
Mounting areas for Alvium USB 90° cameras are the same.
Heat dissipation and housings for bare board cameras
For heat dissipation, see the
Optimum Heat Dissipation for Housed Alvium Cameras
application note.
For designing suitable camera housings, see the
FPC Cables and Embedded Boards
for Alvium USB Cameras
requirement specification.
For electromagnetic compatibility, see the
Electromagnetic Compatibility for Open
Housing Alvium Cameras
application note.
You can find all documents at
https://www.alliedvision.com/en/support/
technical-documentation/alvium-documentation.html
.
NOTICE
Damage to the camera by improper mounting
•
Allow mechanical contact only at the mounting area.
•
Avoid any mechanical stress to the sensor and the electronics area.
•
Avoid short circuits of the electronics components.
•
Give 2 mm minimum clearance above board components.
•
Tighten screws at 0.1 Nm maximum torque.
Figure 23: Mounting area of Alvium USB bare board cameras
connector side (left) | sensor side (right)
i
b
a
a
a
b
a
a
a
Top
