Allied Telesis x330 Series, Руководство по установке

Страница: 67 / 126

x330 Series Installation Guide for Standalone Switches
67
Installing the x330-20GTX Switch
This section contains the procedure for installing the x330-20GTX Switch
in standard 19-inch equipment rack with the RKMT-J13 equipment rack
brackets kit. Here are the required items:

One RKMT-J13 equipment rack brackets kit.

Cross-head screwdriver (not provided).

Flat-head screwdriver (not provided).

Four standard equipment rack screws (not provided).
To install the x330-20GTX Switch in a 19-inch equipment rack, perform the
following procedure:
1. Place the switch on a table.
Note
If the bumper feet are installed on the bottom panel of the switch,
remove them before continuing.
2. Unpack the RKMT-J13 equipment rack brackets kit and verify its
contents. Refer to Figure 21 on page 52.
3. Attach the handles to the RKMT-J13 brackets with the four 3x6mm
screws included in the kit. Attaching the handles is optional. Refer to
Figure 34.
Figure 34. Attaching the Handles to the RKMT-J13 Brackets
4. If you want to recess the front of the switch in the equipment rack
50mm (2 in.), attach the extenders to the brackets with six 4x8mm
screws included in the kit. Refer to Figure 35 on page 68.