Allied Telesis TQ5403, Руководство по установке, Страница: 52 / 82

Chapter 2: Installing the Wireless Access Point
52
Connecting the AC/DC Power Adapter
The wireless access point can be power with PoE+ on the LAN1 port or an
AC/DC power adapter, or both. A wireless access point that is powered by
both methods uses the AC/DC adapter as its primary power and PoE as
redundant power. For an AC/DC power adapter, Allied Telesis
recommends the MWS0091 Power Adapter.
If you purchased a power adapter for the wireless access point, perform
the following procedure. Otherwise, go to “Attaching the Access Point to
the Mounting Bracket” on page 53.
Perform the following procedure to install an AC/DC power adapter:
1. If the AC/DC power adapter has replaceable AC plugs, like the
MWS0091 Power Adapter shown in Figure 5 on page 30, verify that
the current plug on the adapter is the correct plug for your region. If it is
not, install the correct AC plug by following the instructions provided
with the adapter.
2. Plug the DC cable from the power adapter into the DC connector on
the access point. Refer to Figure 20.
Figure 20. Connecting an AC/DC Power Adapter to the DC Connector
3. Connect the power adapter’ into an appropriate AC power source.
4. Push the DC On/Off Button to the “IN” position to turn on the DC
connector.
Note
The DC Power Button controls the DC connector. It does not
control PoE+ on the LAN1 port.
5. Go to “Attaching the Access Point to the Mounting Bracket” on
page 53.