Allied Telesis AT-x950-28XSQ, Руководство по установке

Страница: 145 / 190

AT-x950-28XSQ Switch and VCStack Installation Guide
145
Verifying the Stack
To verify the stack, perform the following procedure:
1. Start a local management session on either the master or member
switch. Refer to “Starting a Local Management Session” on page 127.
2. From the User Exec mode, enter the SHOW STACK command:
awplus> show stack
An example of the command is shown in Figure 80.
Figure 80. SHOW STACK Command
Review the following items:
 The command should list both switches. If the list is incomplete,
refer to Chapter 11, “Troubleshooting” on page 175.

The Operational Status field should be “Normal operations” to
indicate that all of the stacking ports are operating normally.
 If the Operational Status field is displaying “Not all stack ports are
up,” one or more stacking ports are not being used or cannot
establish links with their counterparts. For more information, refer
to Chapter 11, “Troubleshooting” on page 175.
3. Go to Chapter 9, “Cabling the Networking Ports” on page 147, to
complete the installation.
awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID MAC address Priority Status Role
1 - e01a:ea20:8011 1 Ready Active Master
2 - e01a:ea20:8012 2 Ready Member
Operational Status Normal operations
Stack MAC address 0015:774f:ed30