Allied Telesis AT-x510-28GPX, Справочник по командам

Страница: 665 / 2601

C613-50102-01 REV C Command Reference for x510 Series 665
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
P
OWER OVER
E
THERNET
C
OMMANDS
SHOW POWER
-
INLINE INTERFACE
show power-inline interface
Overview This command displays a summary of Power over Ethernet (PoE) information for
specified ports. If no ports are specified then PoE information is displayed for all
ports.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide .
Syntax show power-inline interface [< port-list >]
Mode User Exec and Privileged Exec
Example To display the PoE port-specific information for all PoE ports on the switch, use the
following command:
awplus# show power-inline interface
To display the PoE port specific information for the port range1.0.1 to 1.0.4, use the
following command:
awplus# show power-inline interface port1.0.1-port1.0.4
Output Figure 18-4: Example output from the show power-inline interface command
Parameter Description
< port-list >
Enter the PoE port(s) to display PoE specific information in the show
output.
awplus#show power-inline interface port1.0.1-port1.0.4

Interface Admin Pri Oper Power Device Class Max(mW)

port1.0.1 Disabled Low Disabled 0 n/a n/a n/a

port1.0.2 Enabled High Powered 3840 Desk Phone 1 5000 [U]

port1.0.3 Enabled Crit Powered 6720 AccessPoint 2 7000 [C]

port1.0.4 Disabled Low Disabled 0 n/a n/a n/a

Table 3: Parameters in the show power-inline interface command output
Parameter Description
Interface
The PoE port(s) in the format
portx.y.z
, where
x
is the device
number,
y
is the module number within the device, and
z
is the
PoE port number within the module.
Admin
The administrative state of PoE on a PoE port, either Enabled or
Disabled .