Allied Telesis AT-SBx81CFC960, Руководство по установке

Страница: 295 / 324

SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Section III: Building a Stack with VCStack Plus 295
Displaying the Feature Licenses
The two switches of a stack must have the same feature licenses.
Otherwise, they will not form a stack. To compare the licenses of the
switches, perform the following procedure:
1. Enter the SHOW LICENSE BRIEF command in the Privileged Exec
mode to display the licenses on the switch.
awplus# show license brief
Figure 176 is an example of the information.
Figure 176. SHOW LICENSE BRIEF Command
2. Check the SHOW LICENSE BRIEF command for the following
information:

(1) Verify that the VCStack Plus feature license is included in the
list of licenses. If it is not included, repeat “Activating the VCStack
Plus Feature License” on page 291.

(2) Verify that the VCStack Plus feature is enabled on the switch. If
it is not enabled, repeat “Enabling the Stacking Feature” on
page 293
3. Do one of the following:

If you are configuring the first chassis of the stack, write down on
paper the OEM territory, licenses, and enabled features from the
SHOW LICENSE BRIEF command. You will compare this
information with the license information on the second chassis to
be sure that both units have the same features. After writing the
information, go to “Setting the ID Number” on page 297.
 If you are configuring the second chassis, compare the information
displayed by the SHOW LICENSE BRIEF command against the
license information you wrote down on paper when you configured
OEM Territory: ATI USA
Software Feature License
---------------------------------------------------------------------
0
Base License 1 Base License
1 VCStackPlus 1 VCStack-Plus
Current enabled features for displayed licenses:
IPv6Basic, LAG-FULL, MLDSnoop, RADIUS-100, Virtual-MAC, VRRP, VCStack-Plus
1 2