Allied Telesis AT-FS710/16, Руководство по установке

Страница: 46 / 64

46 46
4. Have another person hold the switch with the brackets at the wall
location where the switch is to be installed. Use a pencil to mark the
wall with the locations of the four holes in the brackets. See Figure 23
as an example.
x
Figure 23. Marking the Screw Hole Locations
5. Pre-drill the marked locations on the wall at the locations marked in
Step 4 as follows:
a. For a wood wall, drill a 1.5mm (1/16”) pilot hole for screw. (No
anchors are required for mounting brackets on a wood wall.)
b. For a sheet rock, concrete or cinder block wall, drill a 6mm (1/4”)
hole for anchor.
6. If the wall you are mounting the unit on is wood construction, then
proceed to Step 8.
7. If the wall you are mounting the unit on is sheet rock, concrete or
cinder block construction, install the four plastic anchors into the wall in
the holes drilled in Step 5.