Allied Telesis AT-10408XP, Руководство по установке

Страница: 36 / 50

Chapter 2: Installation
36
Installing an XFP Transceiver
The AT-10408XP 10-Gigabit Ethernet Switch has eight XFP ports.
Note
The transceiver can be hot-swapped; you do not need to power off
the switch to install a transceiver. However, always remove the
cables before removing the transceiver.
Note
You must install the transceiver before you connect cables to it.
To install an XFP transceiver, perform the following procedure:
1. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
Warning
An XFP transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
transceiver.
2. Remove the dust plug from the XFP slot, as shown in Figure 12.
Figure 12. Removing the Dust Plug from the XFP Slot
3. Locate the label on the transceiver and turn it so that the label is on the
bottom.
7
XFP
8
XFP
STATUS
FAULT
MASTER
PSU1
PSU2
SD
10/100 LI
NK
ACT
1000 LI
NK
ACT
TERMINAL PO
RT
10/100/1000Base-
T
BUSY
NORM
AL
FAULT
1213