Allied Telesis ANC10 Series, Инструкция по установке и эксплуатации

Страница: 31 / 124

ANC10 Network Interface Card Series Installation and User’s Guide
31
Installing the Standard Bracket on the Network Interface Card
The network interface card is shipped with the low-profile bracket already
installed. A standard bracket is included with the network interface card.
Depending on your system, you may need to replace the bracket attached
to your card.
The following procedure describes how to remove the low-profile bracket
from the card and replace it with the standard bracket. You can also use
this procedure to remove the standard bracket and replace it with the low-
profile bracket.
To replace the low-profile bracket with the standard bracket, perform the
following procedure:
1. Remove the two screws that attach the bracket to the network
interface card. See Figure 5.
Figure 5. Removing the Low-profile Bracket
2. Align the tabs of the standard bracket with the holes on the network
interface card and fasten the screws onto the card. See Figure 6 on
page 32.
3.