16
SHOW IGMPSNOOPING ROUTERADDRESS
Patch Release Note
Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E
When using MVR on a Rapier 48 or Rapier 48
i
, multicast packets were not
forwarded correctly between ports 1-24 and 25-48. This issue has been
resolved.
The switch filter was not operating correctly after a boot cycle. This issue
has been resolved.
OSPF disabled RIP unless RIP was activated using the SET OSPF RIP
command. This issue has been resolved.
A fatal error sometimes occurred when IPv6 multicast packets were
forwarded via an interface that went down and then came back up. This
issue has been resolved.
After about 250 days, commands such as SHOW BRIDGE COUNT were not
displaying the correct number of seconds for
Uptime
and
Last Change At
.
days. This issue has been resolved.
Three new commands have been added to enable and disable transmission
of the following ICMP messages:
Network Unreachable
,
Host Unreachable,
and
all
Redirect
messages.
The commands are:
DISABLE IP
ICMPREPLY[={ALL|NETUNREACH|HOSTUNREACH|REDIRECT}]
ENABLE IP
ICMPREPLY[={ALL|NETUNREACH|HOSTUNREACH|REDIRECT}]
SHOW IP ICMPREPLY
For details, see “
Enable and Disable ICMP Messages
” on page 28.
Interoperating with other vendors implementations of ISAKMP was
occasionally causing errors following key exchanges. This relates to
differing implementations of the RFC regarding the retention of leading
zeros. This issue has been resolved by modifying the software to retain
leading zeros. An additional command provides compatibility with routers
that still use previous software versions. The command details are:
SET ENCO DHPADDING={ON|OFF}
This command controls the padding process for Diffie Hellman generated
values. This may be required when interoperability is required with other
vendor’s equipment that uses the Diffie Hellman algorithm.
The DHPADDING parameter specifies whether the Diffie Hellman
generated values should be padded or not. If ON is specified, then leading
zeros will be inserted into the generated values. If OFF is specified, then the
generated values will not be padded. The default is ON.
PCR: 03268
Module: SWI
Level: 1
PCR: 03409
Module: SWI
Level: 2
PCR: 03524
Module: OSPF, IPG
Level: 2
PCR: 03560
Module: IPV6
Level: 2
PCR: 03598
Module: ETH, IPG, IPv6, IPX,
PORT, PPP.
Level: 3
PCR: 03616
Module: IPG
Level: 4
PCR: 03622
Module: ENCO
Level: 2
