Allice Messtechnik R&S ZND, Руководство пользователя, Страница: 342 / 1252

GUI reference
R&S
®
ZND
342 User Manual 1173.9557.02 ─ 61
Peak Left / Peak Right
Sets the active marker to the next local maximum or minimum to the left or right of the
current marker position, depending on the selected
Peak Type .
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute LPEak | RPEak
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Peak Type
Defines the peak type to be searched for using Next Peak and "Next Peak", Peak Left /
Peak Right :
●
If "Max" is active, then the marker is set to the next maximum. The next maximum
is the maximum with the largest response value that is below the current marker
response value.
●
If "Min" is active, then the marker is set to the next minimum. The next minimum is
the minimum with the smallest response value that is above the current marker
response value.
●
If "Min or Max" is active, then the marker is set to the next minimum or maximum,
whichever has the smallest distance from the current marker response value.
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute LPEak | RPEak
Search Range...
Opens the Search Range dialog .
Tracking
Enables/disables tracking of the active marker for the current Search Mode , which cau-
ses the marker to be updated after each sweep (or after each sweep point in case of
"Sweep Progress").
Among the available search modes, the tracking functionality only makes sense for:
●
"Min" and " Max", where such an update typically causes the marker to change
both its horizontal and vertical position and
●
"Target Search", where typically only the horizontal position changes
●
"Sweep Progress" for long duration sweeps
Define an adequate "Search Range" to restrict the search to the adequate frequency or
power interval (see
Chapter 5.7.3.2, "Search Range dialog" , on page 343).
Note: Tracking for bandfilter search can be activated separately, see "Tracking"
on page 353.
Remote command:
CALCulate<Chn>:MARKer<Mk>:SEARch:TRACking
Marker Config...
Opens the Marker Config dialog .
Marker softtool
www.allice.de Allice Messtechnik GmbH