Connection Time!
Connect the Ground terminal to the closest point on the chassis of the car. This
connection should be no longer than 36” in length. Use 4-gauge (or heavier) wire.
Connect the Remote terminal to the remote output of the head unit. Use 16-gauge (or
heavier) wire.
Connect Power wire to battery. Make sure to use an inline fuse that matches the
ratings called out for your amplifier at the end of this manual. The inline fuse should be
mounted within 18” of the car battery. Use 4-gauge wire (or heavier) from the fuse
location to the amplifier.
Connect all inputs and outputs (if used) using high quality cables. For best results
always use pure copper cable.
Connect all speakers using high quality speaker cable. Be sure to observe proper
polarity to avoid audio phase issues.
Recheck all connections before powering the amplifier.
Set all level controls to minimum position and set all crossover controls/switches to the
desired frequency points.
Power up the head unit and amplifier. Set the volume control on the head unit to about
¾ the volume and adjust the amplifier input level control(s) to just below the level of
distortion.
When adjusting the amplifier, please remember, the input level control is not a volume
control. It is designed to match the output level of your audio source to the input level
of your amplifier.
Specifications
Fuse Recommendations:
VL1000D – 20A
VL1500D – 30A
VL2000D – 50A
VL3000D – 60A
VL4000D – 90A
VL1500D
1
4
Peak Power: 1500W
Power RMS 1
Ω
@ 14.4V: 1 x 375 Watts
Power RMS 2
Ω
@ 14.4V: 1 x 87.5 Watts
Power RMS 4
Ω
@ 14.4V: 1 x 93.75 Watts
THD+N @ Nominal Power: 1 x 375 Watts 1
Ω
Frequency Response: 15Hz ~ 250Hz
SNR: 91dB
Input Sensitivity: 0.2V to 9V
Damping Factor: 150
Operating Voltage: 9V to 16V
High Pass Filter: 10Hz to 50Hz
Low Pass Filter: 50Hz to 220Hz
Max Current Draw (A): 45
Music Current Draw (A): 24
Dimensions: 5.8” W x 7” L x 1.9” H
+12V REM GND
POWER INPUT
SPEAKER OUTPUT
MONO
F U S E
