Alliance Laundry Systems UL15F069, Руководство по установке и эксплуатации

Страница: 13 / 27

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
11
1800001
Moving Finisher with Crane
1. Remove any obstacles under machine placement
area.
2. Fasten lifting cables to lifting eyebolts. Refer to
Figure 2 .
3. Lift machine.
4. Make sure cable is positioned correctly so that
machine hangs horizontally.
5. Lift machine carefully, without sudden shocks or
movements.
6. Place machine on ground, as close to the
permanent location as possible.
7. If the machine needs further moving, use forklift
or rollers. Refer to Moving Finisher with Forklift
section.
IMPORTANT: To use rollers place rollers in four
corners, distributing weight evenly.
8. Once finisher is in final position, open hydraulic
valve to release chest.
9. Remove all packing materials.
10. Level finisher.
Moving Finisher with Forklift
The finisher should be moved with a forklift as close
as possible to the area where it will be installed. Use a
forklift of sufficient capacity to lift the packaged unit
according to the following procedures.
IMPORTANT: DO NOT lift finisher with slings.
1. Position the forklift arms beneath the center of
the unit in the built-in forklift slots. Refer to
Figure 3 .
IMPORTANT: Lifting the finisher from either side
could cause misalignment and/or damage to the
finisher.
Figure 3
2. Use the forklift to carefully lift the packaged
finisher off wooden skids. Refer to Figure 2.
3. Move the packaged unit as close as possible to
the area where the finisher will be installed.
IMPORTANT: DO NOT lift the unit more than 8
inches (203 mm) off the ground.
4. If the machine needs further moving, place
rollers in all four corners off finisher, distributing
weight evenly, and roll into place.
5. Once finisher is in final position, open hydraulic
valve to release chest.
6. Remove all packing materials.
7. Level finisher.
FWF49N
Figure 2
FWF49N
Lifting
Eyebolts
FWF56N