Alliance Laundry Systems LWS01M series, Руководство по устранению неисправностей

Страница: 28 / 36

26
39311
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 4
Adjustments
18. Leveling Legs
Refer to Figure 1.
a. Place rubber feet on all four leveling legs.
b. Place washer in position on a clean, dry, and
reasonably firm floor.
c. Loosen locknuts and adjust two front leveling
legs. Once adjusted, tilt washer forward on
front legs and lower back down into position
to set the rear self-leveling legs.
d. Washer must not rock. After washer is at
desired height, tighten locknuts securely
against bottom of washer base. If these
locknuts are not tight, washer will not remain
stationary during operation.
NOTE: Improper installation, installation on carpet
or flexing of a weak floor will cause excessive
vibration.
IMPORTANT: Do not slide washer across floor
once leveling legs have been extended, as legs and
base could become damaged.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
Figure 1
W456SE3A
Level
Washer
Base
Locknut
Leveling
Leg
Rubber
Foot