68
800793
Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
44. MOTOR BELT
NOTE: Belt adjustment procedures are done
through front of washer, however, as an option,
washer can be moved from its location and belt
adjustment can be done through lower access panel
opening at rear of washer.
a. While supporting lower front access panel,
remove two screws from bottom edge of access
panel and remove panel. Refer to Figure 9.
b. Run belt off cylinder pulley while slowly
turning pulley. Refer to Figure 23.
c. Remove belt from motor shaft.
NOTE: When installing belt, adjust belt tension as
follows:
d. Working through the lower front access door
opening, place a locking pliers on the metal rod
and loosen the two adjusting bolts. Refer to
Figure 22. Repeat procedure to loosen the two
pivot bolts. Refer to Figure 23.
e. Pull down on motor to increase belt tension.
Use a Burroughs belt gauge to obtain proper
tension. Proper belt tension is obtained when
belt can be deflected approximately 1/4 inch
(6.35 mm) from normal position when
moderate pressure 50 to 60 pounds (22.68 to
27.22 Kg) is applied to a point midway between
pulleys. Refer to Figure 23.
f. After proper belt tension has been obtained,
tighten belt adjusting bolts firmly, then tighten
pivot bolts. Refer to Figure 23.
