53277
37
Section 4 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
42. CYLINDER ROLLERS AND ROLLER
SHAFT
Refer to Figure 34
a. Pull cylinder forward slightly to gain access to
cylinder rollers.
b. On models with roller bearing style, remove
nut on roller bearing shaft and remove shaft and
bearing.
c. On models with snap ring, remove snap ring,
roller and washers and remove shaft.
d. On newer units, brackets can be removed by
removing 2 screws attaching roller bracket to
rear bulkhead.
43. REAR BULKHEAD AND HEATER BOX
a. Remove cylinder assembly. Refer to Paragraph
40.
b. On Gas Models, remove burner housing and
heat shroud. Refer to Paragraphs 26 and 27.
c. On electric models, remove heating element.
Refer to Paragraph 28.
d. Remove two hex head screws holding bottom
end of heater box to heat shield. Refer to
Figure 33.
e. Remove Phillips head screw holding rear
bulkhead to terminal block bracket and four
Phillips head screws holding rear bulkhead to
mounting brackets. Refer to Figure 33.
f. Lift entire assembly out of cabinet.
TO REMOVE HEATER BOX FROM REAR
BULKHEAD
a. Refer to Figure 35 for removal.
Figure 34
DRY955S
ROLLERS
ROLLER
NUT
WASHER
Figure 35
REAR
BULKHEAD
HEATER BOX
ATTACHING
SCREWS
HEATER
BOX
DRY866S
