505872
41
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
35. LINT FILTER
Refer to Figure 16
a. Open loading door and remove screw on each
end of lint filter.
b. Lift filter out of air duct.
NOTE: Be sure to replace the filter with the words
“FRONT” facing the front of the dryer.
36. LOADING DOOR
Remove four screws holding hinges to door. Refer
to Figure 16.
37. INNER AND OUTER DOOR PANELS AND
DOOR HANDLE
a. Remove four screws holding hinges to door.
b. Remove screws holding handle to door and
separate panels. Refer to Figure 17.
IMPORTANT: Do not over-tighten screws when
reinstalling door handle and avoid scratching inner
door panel.
Figure 16
DR029-IN-1
LINT
FILTER
HINGE
SCREWS
