Alliance Laundry Systems DT120CSH, Установка, эксплуатация и обслуживание

Страница: 70 / 172

68
M413620
ELECTRONICALLY CONTROLLED OPL TUMBLER
INTRODUCTION
Drying can be done automatically or by time dry. When
drying automatically, the tumbler stops drying when
laundry reaches the factory set or programmed dryness
level and starts cool down. When time drying, the
tumbler stops drying when programmed time ends and
starts cool-down.
Special Cycle allows user to specify the number of
heating cycles and specify temperature from 80°F (27°C)
to 180°F (82°C) for all heat cycles.
Special Time allows user to specify temperature from
80°F (27°C) to 180°F (82°C) for all heat cycles.
Both automatic and time dry have factory-set cycles, but
other cycles can also be created. Frequently used cycles
can be saved in the control's memory as Custom cycles,
see Figure 35.
A drying instructions chart is included for recording
selections and settings for various load types, Figure 41.
In all cycles, except No Heat, Wrinkle-Free begins when
Cool Down ends. During Wrinkle-Free, the tumbler
alternately stops for 2-1/2 minutes and then runs without
heat for 2-1/2 minutes until door is opened or 60 minutes
has elapsed.
All pads can be pressed in any sequence without
damaging control or tumbler. To stop the tumbler at any
time, open the door or press STOP/RESET. The window
display will flash. Press STOP/RESET twice (within 3
seconds) to end the cycle and reset the control to idle
status, see Figure 34.
NOTE: Not all tumblers will have reversing option.
Figure 34
OPL Micro Control Panel