Alliance Laundry Systems BWNBC2PP112TW01, Программирование

Страница: 23 / 28

Testing Machine and MDC Functions
This feature allows the owner to run diagnostic tests on various
washer operations without servicing the washer. The following
tests are available:
• Show Fill Time Test
• Show Drain Time Test
How to Enter Testing Feature
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode .
2. Press the PERM PRESS/WARM (
∧
) or the DELICATES/
COLD (
∨
) keypad until
dIAg
appears in the Four-Digit Dis-
play.
3. Press the START (enter) keypad. Display will change to
d001
.
4. Press the PERM PRESS/WARM (
∧
) or the DELICATES/
COLD (
∨
) keypad to scroll through the diagnostic test op-
tions.
How to Start Tests
1. To start a diagnostic test, refer to the quick reference chart be-
low.
2. Press the START (enter) keypad when the desired test number
is displayed. For detailed information on each test, read the
appropriate description.
How to Exit Testing
While pressing and holding the NORMAL/HOT keypad with
one hand, press the NORMAL/WARM keypad with the other
hand. The display will return to the previous mode of opera-
tion.
Diagnostic (Testing) Mode – Quick Reference Table
Test Number
Diagnostic
Mode
Four-Digit Dis-
play
d001
Show Fill Time
Test
F---
d002
Show Drain Time
Test
d---
Table 3
Diagnostic Test Descriptions
Show Fill Time Test
This test will display the average fill time. The average will be
calculated by taking the average of the last four fill times.
To start test, control must be in the Testing Mode. Refer to How
to Start Tests .
To enter, press the START (enter) keypad. The Four- Digit Dis-
play will show
F---
. The
---
will be the average fill time in
minutes and seconds for that machine.
To exit the Show Fill Time Test, press and hold the
NORMAL/HOT keypad with one hand, then press the NOR-
MAL/WARM keypad with the other hand. The control will return
to the Testing Mode and will display
d001
.
Show Drain Time Test
This test will display the average drain time. The average will be
calculated by taking the average of the last four drain times.
To start test, control must be in the Testing Mode. Refer to How
to Start Tests .
To enter, press the START (enter) keypad. The Four- Digit Dis-
play will show
d---
. The
---
will be the average drain time in
minutes and seconds for that machine.
To exit the Show Drain Time Test, press and hold the
NORMAL/HOT keypad with one hand, then press the NOR-
MAL/WARM keypad with the other hand. The control will return
to the Testing Mode and will display
d001
.
Production Test Cycle
To Enter Production Test Cycle
1. Be certain control is in Ready Mode, washer lid is closed, and
access panel or coin vault is open.
2. While pressing and holding the NORMAL/ WARM keypad
with one hand, press the PERM PRESS/WARM keypad with
the other hand.
3. When the control enters the Production Test Cycle, it will first
display
S---
with the
---
showing the software version of
the control.
4. The control will advance through the sequence of test steps
whenever NORMAL/WARM is pressed, with the exception
of the Keypad Test and Step #4 Test. Refer to
Table 4 for all
tests in the Production Test Cycle.
Testing Machine and MDC Functions
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
23 Part No. 202713ENR1