Please connect the terminal block (see
illustration 1) as follows:
1.
Connect the live wire (coloured
red or brown) to the terminal
marked ‘L’.
2.
Connect the neutral wire (coloured
black or blue) to the terminal
marked ‘N’.
3.
Connect the earth wire (coloured
green and yellow) to the terminal
marked ‘ ’.
P.02
P.03
Mounting instructions
The Hand Dryer must be fixed to a solid
supporting wall. The recommended
distance from finished floor level to
the bottom of the unit should be as
follows:-
• Male washrooms
1168mm
• Female washrooms
1118mm
• Disabled washrooms
1016mm
• Children aged 14-17
1118mm
• Children aged 11-13
1016mm
• Children aged 8-10
914mm
• Children aged 4-7
672mm
Wiring instructions
Always ensure that the installation
conforms to the current edition of
the I.E.E. wiring regulations, BS 7671
(UK) or the appropriate standards in
your country. Ensure that the unit is
separately fused with a suitably rated
fuse and that it is connected to the
supply with a double pole isolating
switch having a contact separation of
at least 3mm. Care should be taken
that single insulated conductors cannot
come into contact with the mounting
surface.
To ensure ease of installation and
subsequent maintenance, the horizontal
distance to any adjacent wall should
not be less than 0.2 metres.
To install follow the steps below:
1.
Drill 7mmø x 50mm deep four
places using template supplied
to mark up position (For fitting to
masonary).
2.
Insert nylon plugs.
3.
Screw in screws leaving
1
2
WARNING
The hand dryer MUST be isolated from the power
supply during installation or maintenance.
IMPORTANT
After installation or servicing, units must be checked,
and only left when electrically and mechanically safe.
L
N
