ALL
FASTENERS.COM
|
14
()
15. PREPARING THE BATTERY
Read section titled “6. SAFETY INSTRUCTIONS - BATTERY CHARGER” before moving forward.
You must charge the battery before use. The charging method for the battery is show under “CHARGING METHOD” of the
“12. REMOVAL, INSTALLATION & CHARGING” section of this manual.
16. MAGAZINE ASSEMBLY INSTALL
1.
REMOVE FUEL CELL AND BATTERY FROM NAILER.
2.
Fit on magazine assembly. Insert magazine
into the nail seat. See drawing 16.A.
3.
Lock magazine into nail seat by turning
the lock knob. See drawing 16.B.
WARNING
Never use the AF Gas Nailer after taking off the magazine.
17. TESTING THE NAILER
DANGER
Operators and others in work area MUST wear safety glasses with side shields that conform to safety
regulation specifications.
WARNING
Never use nailer unless push lever is operating properly.
The machine employs a preventative mechanism for unloading operation.
The machine enters a state where the push lever cannot be pushed up. This takes place when the magazine is not loaded with nails or
when the remaining number of nails becomes less than 2 or 3.
CAUTION
Use caution not to throw the push lever tip onto any object.
Before actually beginning the nailing work, test the nailer by using the checklist located on page 14. Conduct the tests in the following
order. If abnormal operation occurs, stop using the tool and contact Allfasteners, LLC. at 1-800-577-3171 for further instructions.
16.A
16.B
Magazine
Assembly
Lock Magazine
Assembly
Battery Pack
Lock Knob
1.
REMOVE FUEL CELL AND BATTERY FROM NAILER.
ALL SCREWS MUST BE TIGHTENED.
THE PUSH LEVER AND TRIGGER MUST MOVE
SMOOTHLY when pulling back the feeder knob.
2.
Install the battery. DO NOT operate the push lever or trigger
while installing the battery. Make sure the battery indicator
light is flashing green. If the battery indicator light is flashing
red, the battery does not have enough power and it needs to
be charged.
Trigger
Nail Feeder
Handle
Battery Pack
Insert
