F016J13542-A ISSUE 28-01-22 SE
12
ASSEMBLY
Assembling the handle to the mower (See Fig. A)
WARNING!
- Remove the battery from the mower to prevent accidents during assembly
1. Locate the electrical connector on the handle, next locate the mating connector one on the mower. The
connector on the mower will be on the rear right-hand side near the base of the top cover. Push the
connectors together making sure the mating orientation is correct and the lock is secure.
2. Start with the handle lying flat on the ground. Next locate the slots in the chassis and the blocks where
the handle will be mounted. It is important that the handle electrical wiring goes through the right-hand
slot in the chassis first (right hand from
operators’ position). With the wiring in place position the handle
on the mower, pass the handle through the slots so it rests in the mounting blocks. Tuck any spare cable
in the tray below the mounting blocks.
3. Pivot the handlebars up and lock in the upright storage/maintenance position using the quick adjust lever
(see section on Handle height adjustment)
4. Fit the cover plate to secure the handle to the mower. Use 4 x M6 x 50mm fasteners, 4 x M6 washers
and 4 x M6 nyloc nuts. Tighten the nuts with a minimum torque of 12Nm
Assembling the grass bag (See Fig. B)
How to assemble the grass bag
1. Fold both side frames out
2. Attach the cross bars to secure the frame in the open position, please take note of cross bar orientation
in Figure B
3. Fit the fabric grass bag over the frame so that the solid material base is opposite the handle, secure with
the plastic clips
How to fit the grass bag to the mower (See Fig. C)
Locate the grass bag frame into the slots on both sides of the mower chassis (See Fig C)