allen MSP465, Инструкция по безопасности и эксплуатации

Страница: 29 / 54

This machine is built with user safety in mind. However, it can present hazards if improperly
operated and serviced. Follow operating instructions carefully.
If you have any questions about operating or servicing this equipment, please contact your
Allen Engineering Dealer or AEC Customer Service at 800-643-0095 or 870-236-7751.
The MSP465 riding trowel is a modern high production machine. Finishing rate will vary depending on the operators skill
and job conditions. This riding trowel has ten finishing blades.
The Super Heavy Duty (SHD) Gearboxes are designed to provide exceptional performance with low maintenance and
trouble free use under some of the worst conditions.
All Allen Engineering MSP465 Riders are equipped with a safety shutdown switch and a low oil warning for added job
safety and engine protection. Operating time between fuel refills is approximately 2-1/2 to 3 hours depending on rotor
speeds.
Before Starting Procedures
Before starting the riding trowel check for the following:
1. Oil level in engine.
2. Oil level in riding trowel gearboxes.
3. Fuel level in fuel tank.
4. Condition of air filter on engine.
5. Condition of riding trowel arms and blades.
6. Verify that daily maintenance of grease points have been performed.
Starting Procedures
Turn ignition switch key to the start-position, immediately release key when engine starts. Allow engine to
warm up for 5 minutes before operating riding trowel.
Operating the starter for more than 5 seconds can damage the starter or
engine. If engine fails to start release the switch and wait 15 seconds before
operating starter again.
Introduction to MSP465
/ Start-up Procedure
SECTION 2
OPERATIONS
069598 Page 29