Page
Page
EC Declaration of conformity
Responsible authority in a member state
where a copy of this declaration has been sent
United Kingdom
DTI
PO box 1302
Bristol
BS99 2GB
Manufacturer or responsible person established in
the community
Allen Power Equipment Ltd
The Broadway
Didcot
Oxfordshire
OX11-8ES
Name, and if different the address of person holding
the technical documentation.
Service & Technical Manager
Description of Equipment:
Category/Article: - Hover Grass trimmer
Cutter- width: 446mm Type- flexible line
Model/Type: Domestic 45
Net installed power or other noise - related Value:
3.4kW (4.5)hp
Measured sound power level:
dB (A) 96.9 dB(A)
Guaranteed Sound power level
dB (A) 98 dB(A)
Conformity assessment procedure and name and
address of notified body if appropriate;
Assessment procedure:
2000/14/EC (Annex V)
Address: Intertek ETL SEMKO
Davy Avenue
Knowhill
Milton Keynes
MK5-8NL
Vibration measured at:
I the undersigned certify that the product complies with:
The requirements of the Standards/Directives.
ISO 11806 (2000/14/EC)
ISO 10518 : 1991 (98/37/EC)
ISO 14982 : 1998 (89/336/EC)
Particulars of the signatory authorised to sign the declaration
Place and date of the declaration
Service and Technical Manager
Allen Power Equipment Ltd
December 2005
Certificate of conformity
Fault finding:
Poor Starting
1.
Make sure the petrol tap is open.
2.
If the engine is COLD the throttle control should be in the START [fig 15] position.
If WARM, in the RUN [fig 14] position.
3.
If the trimmer has been out of use the petrol may be stale. Drain and replace.
4.
Check the air filter for excessive oil. If this is the case, fit a new filter [see fig. 24].
5.
The engine may be flooded with fuel, in which case, remove and dry the spark plug. Before replacing, crank
the engine to remove excess fuel.
6.
Check the plug for spark by placing the end of the plug (with lead connected) against the engine casing and
away from the plughole.
DO NOT HOLD THE PLUG OR LEAD BY HAND.
Crank the engine and watch for a spark at the plug points. If there is no spark, the plug should be replaced.
7.
Make sure the cutting disk is correctly fitted and tight.
If none of the above steps solve the problem - see your local dealer.
Poor hovering
1.
Check that the cutting disk is fitted firmly.
2.
Check that the impeller air vents are not blocked.
3.
Check that the underside of the deck is really clean.
4.
Check that the engine is running at the correct speed - see your local dealer.
Excessive vibration
1.
Check cutting disk and spacers are fitted correctly.
2.
Check all screws and bolts are tight.
3.
If the blade has hit a heavy object the impeller crankshaft may be damaged. (See dealer.)
Engine Overheating
1.
Make sure the engine cooling fins are dirt-free.
Ordering parts
When ordering a part please state is for the Allen Domesitic 45.
The serial number may be needed - it is located on the sticker shown on p13.
There are two stickers located on your trimmer beneath the handlebars behind the engine.
Allen Power Equipment Limited
Model: 45 Domestic
Serial No:________________
3.4kW @ 3100rpm
The Broadway Didcot
Oxfordshire OX11 8ES
Made in England
Serial no.: ..................................................................................................
Date of purchase: ....................................................................................
Purchased from: .......................................................................................
......................................................................................................................
Winter storage:
We recommend your lawn trimmer is serviced by your local dealer after the last cut of the season,
before storage.
Before storing, carry out the following:
1.
Ensure the petrol is drained from the tank.
2.
Then run the engine until it uses up the remaining fuel.
3.
Close the fuel tap - see fig 11.
4.
Disconnect the spark plug lead - see fig 10.
5.
Drain and replace the engine oil. [See manufacturers handbook]
6.
Store the machine so that the deck and engine are horizontal to the ground.
N.B. - Stale fuel is a major cause of non-starting at the beginning of a season.
EC Declaration of Conformity
Содержание Domestic
Страница 1: ......
Страница 2: ...1 2 4 3 5 6 7c 7b 7a 7 7d Page ...
Страница 3: ...Page Page A OFF ON E H I D C B F G 8 16 9 10 11 12 15 14 13 17 18 19 ...
