allen AW16-H, Инструкция по безопасности и эксплуатации, Страница: 69 / 78

Tying Down a Buggy onto a Trailer or Truck Bed
FAILURE TO FOLLOW ALL OF THE FOLLOWING STEPS WHEN TYING DOWN A BUGGY MAY
RESULT IN SERIOUS INJURY OR DEATH.
1. Make sure the bucket is completely empty.
2. Lower the bucket completely against the buggy frame.
3. Lower the operator’s platform to the down / stand-on position.
4. The truck or trailer bed must be equipped with tie-down rings at the front and rear in
order to secure the buggy as shown below.
5. The trailer bed or trailer must be level. Parking brake must be on and transmission in gear.
6. The buggy must be placed correctly on the truck or trailer bed with the buggy’s parking brake engaged and
locked, engine off and fuel supply turned off at the carburetor (13 HP Honda engine only).
7. Attach two (2) chains or straps through the ring in the front of the buggy frame and through the two (2) rings
mounted at the front of the trailer or truck bed.
8. Attach one (1) chain or strap through each of the rear cutouts at the rear of the buggy frame and through the
corresponding rings mounted at the rear of the trailer or truck bed.
9. All chains/straps must pull away from the buggy and toward the tie-down rings.
10. Tighten chains/straps with appropriate binders or ratchets until all slack is removed.
11. Block both front and rear wheels of buggy as shown below.
EMPTY BUCKET AND RETURN TO FULL
LOWERED POSITION
CHOCK WHEELS
CHOCK WHEELS
TIE DOWN FRONT OF
BUGGY AT 1 PLACE AT
FRONT LOOP
PULL TIE DOWN AWAY
AND TO THE FRONT.
TIE DOWN REAR OF
BUGGY AT 2 CUTOUTS
APPLY PARKING
BRAKE
PULL TIE DOWN AWAY
AND TO THE REAR.
3.11 - Tie Down Procedures
SECTION 3
SERVICE
055838 Page 69