allen 060800, Руководство по эксплуатации и запасным частям

Страница: 35 / 114

061090 - 12/2013
SECTION 2
OPERATIONS
Page 2-3
Pre-Operating Instructions - cont’d
Before starting riding trowel, locate and identify the operational and visual controls pertaining to the
operation of the riding trowel.
1) Sit down correctly on the riding trowel seat. DO NOT attempt to start the riding trowel
without an operator in the seat. This machine is equipped with an automatic shut down
system via a kill switch pedal.
2) Turn key counter-clockwise until the glow plug light goes off then clockwise until the
engine engages and starts.
To much throttle during start-up will fl ood the engine.
3) Turn key to the run position and allow spring back. Allow engine to warm up before
operating trowel.
Operating the starter for more than 5 seconds can damage the starter or engine.
If engine fails to start release the switch and wait 15 seconds before operating
starter again.
Cold Start-up Procedures
When ambient temperatures are below 60°F (16°C) cold weather startup procedures must be followed
before bringing machine into maximum engine RPM and rotor speed. If the procedure is not followed,
damage could occur which will void the warranty. See below for startup procedure.
When ambient temperatures are below 60°F (16°C) run engine at 1/4” throttle. There is an arrow (A) lo-
cated on a decal showing where the throttle lever’s front edge should be located. Engage the rotors
by pressing on the right foot pedal for approximately 5 to 7 minutes to allow the engine system time to
adequately warm up before operation.