Lowes.com/allenandroth
9
10. Carefully lift the fan and seat the hanger ball of
downrod assembly (B) on the mounting bracket (A)
attached to the outlet box.
Note:
Be sure one of the four slots in the hanger ball
is lined up with the tab on the mounting bracket (A).
DANGER:
Be careful when aligning the tab to
the slot! If not fully engaged, there is a possibility of
the fan falling, which may result in serious injury
or death.
10
A
B
C
Tab
Slot
Hanger
Ball
INITIAL INSTALLATION INSTRUCTIONS
ON
1 2 3 4
DIP
DIP
ON
1. To sync the remote from power kit (T) to the receiver
also in power kit (T), first remove the battery
cover from the remote and slide code switches to
your choice of up or down position using a small
screwdriver or ballpoint pen (neither included).
Replace battery cover on remote. Then, slide the
code switches on the receiver to the same positions
as set on the remote.
Note:
Factory setting is all up; do not use this
position.
1
WIRING INSTRUCTIONS
WARNING:
To avoid possible electrical shock, be sure electricity is turned off at the main fuse
box before hanging.
WARNING:
If house wires are of different colors than referred to in the following steps, stop
immediately. A professional electrician is recommended to determine proper wiring.
Note:
If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it
must be grounded for safe operation.
Note:
The remote from power kit (T) has 16 different code combinations. To prevent possible
interference from or to other remote units, simply change the combination code in your remote and
receiver as described in Step 1 below.
Remote
Receiver
