ASSEMBLY INSTRUCTIONS FOR HARDWIRE INSTALLATION
7. Remove the hex nut preassembled to plug button
(EE). Then insert the plug button (EE) through
grommet (J) and secure with the hex nut.
Hardware Used
EE
Plug Button
x 1
8. Make the following wire connections using the wire
connectors preassembled to the fixture (A) wires:
• Push the Bare/Green (ground) supply wire into the
empty wire hole of the wire connector preassembled
to the Copper wire. Lower the lever to secure.
• Push the White (neutral) supply wire into the empty
wire hole of the wire connector preassembled to the
White wire. Lower the lever to secure.
• Push the Black (hot) supply wire into the empty
wire hole of the wire connector preassembled to
the Black wire from the switch. Lower the lever to
secure.
Note:
If household supply wires are different
colors than referred to above, it is recommended a
professional electrician determines the proper wiring.
9. Insert the two screws preassembled to the mounting
bracket (FF) through the two holes in the fixture (A)
and secure with the two screw caps (C).
Note:
It may be necessary to adjust the hex nuts, and
long screws preassembled to the mounting bracket
(FF), to ensure the fixture (A) will fit securely on the
long screws.
9
8
White
(neutral)
White
Black (hot) Black
Copper
Outlet
Box
Hex Nut
Bare/Green
(ground)
7
A
EE
J
Hole
Screw
A
C
FF
10
