Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
65
Configure the Stratix 5900 Services Router by Using CISCO IOS Command-line Interface (CLI)
Chapter 4
User Access Verification
Username:
3.
Enter the username username1 and press Return or Enter.
Password:
4.
Enter the password password1 and press Return or Enter.
Router#
A message appears that is similar to the first warning message. The message
directs you to change the username and password.
You are now in privileged EXEC mode.
To change the username and password follow these steps.
1.
Enter the following at the prompt:
username
username
privilege 15 secret 0
password
The username and password are the username and password that you
determine.
2.
Verify the initial configuration.
See
Discover the Router on page 41
for more information.
TIP
You must change the username and password before you log off the
router. You cannot use the username username1 or password
password1 after you log off from this session.
TIP
Save your configuration changes regularly to avoid losing them during
resets, power cycles, or power outages. Use the copy running-config
startup-config command at the privileged EXEC mode prompt
(Router#) to save the configuration to NVRAM.
