28
Rockwell Automation Publication 6300B-UM002A-EN-P - October 2020
Chapter 5 Clean the Wall Mount Box PC
6. Inspect each filter. Replace if dirty.
7. Check the vent holes (D) that the filter plates cover.
If necessary, vacuum dust and debris from them.
8. Install the new filters or cleaned filters in each filter plate.
9. Reinstall both filter plates on the box PC.
10. Tighten the two screws on each filter plate.
11. Reconnect power to the computer at the power source.
IMPORTANT
If dirty filters cannot be replaced immediately, Rockwell
Automation recommends that you do one of the following:
• Use a vacuum cleaner
• Wash them with warm water and a mild detergent (such as
dishwashing liquid), rinse, and then air dry
However, both procedures decrease the efficiency of the filter.
Therefore, it is best to replace the filter as soon as possible.
