ALLEN & HEATH
MIXWIZARD WZ14:4:2 SYS-LINK OPTION
4
Buss wires
Locate Stereo input 13-14 circuit board assembly and Group 1 circuit board assembly. Cut the
TC buss wires 5mm from the component side of the Stereo input circuit board assembly and bend
the TC buss wires vertically.
Slide the SYS-LINK circuit board in between the Stereo input channel and Group 1circuit board
assemblies. Take care not to damage the ribbon harnesses already connected to the circuit
board.
Cut each wire 5mm from the component side of
stereo input 13-14 circuit board assembly and
bend wires vertically up.
Buss wires
Refering to fig. 1, fig. 5 & fig.6, form harness C as shown and prepare the solder pads on the circuit
boards with new solder to ease the soldering of the SYS-LINK wires.
Note, the wires are soldered to the trackside of the circuit boards and not the component
side.
It is recommended that the wires in the SYS-LINK harness are soldered to each circuit board in
the following order:
RIGHT PCB then LEFT then GROUP 4 then GROUP 3 then GROUP 2 and then finally GROUP
1 PCB.
SOLDERING THE SYS-LINK HARNESS ASSEMBLY:
•
•
fig. 4
ò
SYS-LINK
circuit board
ê
ê
FITTING THE SYS-LINK CIRCUIT BOARD ASSEMBLY
Slide SYS-LINK circuit
board between Stereo
input 13-14 & Group 1.
