M-DL-GOPT fitting note
3
AP10843 Issue 1
Use the
MixRack / Audio / Audio Sync
screen to select the clock source. Set
this to Internal on the master system, or to the relevant I/O Port on all other
networked (clock slave) systems.
For more information on dLive setup and functions please
refer to the dLive Firmware Reference Guide available for
download at
Convert mode
Patch the built-in MixRack/Surface gigaACE Port A into the Port A EtherCon of
the fibreACE card on each side of the connection, using a short CAT5e (or higher
specification) cable. Use two cables for redundancy (not available on CDM
MixRacks and C Surfaces). No software setup is required.
