DT20 Getting Started Guide
AP12432 _1
Front panel
Input sockets
Balanced combi mic/line inputs. The TRS inputs have an integrated 20dB Pad for use with
line level signals.
Gain
Rotary control for the analogue gain of the preamp, 0dB to 55dB. To prevent any tampering with
the gain level, the knobs can be removed and replaced with the blanking lids provided.
PP
+48V Phantom Power switch and indicator.
Rear panel
Dante
EtherCon port for connection to the Dante network and Link / Activity LED indicator. Use a PoE
Ethernet switch or PoE injector to power the unit via this port.
Power
LED indicator and
Ready
indicator.
Ready
lights up when the unit is successfully booted and
ready to pass audio.
Factory Reset
Hold down the recessed switch while powering up. After at least 10 seconds, remove
power then power up again normally to reset the network settings and name. This will delete any static IP
address and revert to factory default (DHCP / zero-conf).
DC input
DC 12V connector. Only use with the power supply provided with the unit.
