DT02 Getting Started Guide
AP12431 _1
Front panel
Output sockets
Balanced line-level XLR outputs.
Rear panel
Dante
EtherCon port for connection to the Dante network and Link / Activity LED indicator. Use a PoE
Ethernet switch or PoE injector to power the unit via this port.
Power
LED indicator and
Ready
indicator.
Ready
lights up when the unit is successfully booted and
ready to pass audio.
Factory Reset
Hold down the recessed switch while powering up. After at least 10 seconds, remove
power then power up again normally to reset the network settings and name. This will delete any static IP
address and revert to factory default (DHCP / zero-conf).
DC input
DC 12V connector. Only use with the power supply provided with the unit.
