asd9doc01
●
Lockbody screv
SD9
for sliding screen doors
ILLUSTRATED FITTING INSTRUCTIONS
●
Lockbody screws.vv
1. LOCKBODY INSTALLATION
4. EXTERIOR FURNITURE
3. INTERIOR FURNITURE
●
The
Sticker
on the rear of
the
Lockbody
is to assist
in easy installation. - Do
not remove.
●
If the
Sticker
has been
broken or removed,
ensure that the
Rear
Slide
is pushed
completely down
before assembling the
Lockbody
into the door
cutout.
●
Insert the
Lockbody
into
the door cutout
●
Secure the
Lockbody
with the two #8x13mm
Lockbody screws.
Sticker
Rear Slide
2. CYLINDER INSTALLATION
●
Assemble the
Cylinder
through the lock so the
Cylinder
protrudes
equally from both sides.
NOTE : the
Cylinder
Cam
must rotate as
shown below. (cam turns
towards front of door)
●
Insert the
Key
and turn
to locked position.
●
Insert #10 x 38mm
Cylinder Screw
&
tighten.
NOTE : test,
Main Bolt
should not depress.
●
Turn
Key
to unlocked
position and remove
Key
.
Cylinder
Screw
Cylinder
Cylinder
Cam
IMPORTANT : If installing with a multipoint accessory kit, be
sure to follow the cylinder installation procedure within the
multipoint kit instructions.
●
Select the
Exterior Handle
assembly.
●
Select the
Interior Handle
to suit your door, then
punch out the
Snib Hole
Cover
.
◦
(Place the punch on the
Austral Logo and punch
from the front.)
●
Break the
Snib Lever
pair
in two.
●
Install the correct
Snib
and
Lever
as shown.
LH
escutcheon
set up for Interior.
LH
escutcheon
set
up for exterior.
RH
escutcheon
set up for Interior.
●
Fit the Snib Plug in behind
the Austral logo of the
Exterior Escutcheon.
◦
Hold the
Snib
vertical
and and insert it into the
Escutcheon
. Secure by
rotating the
Snib
90 ° to
the position shown.
PLEASE TURN OVER
Austral
宏
ock
