Allavino VSWB-2, Инструкция по эксплуатации

Страница: 5 / 14

www.allavino.com 5 1-888-980-4809
Installation Instructions
BEFORE USE:
•
Remove the exterior and interior packaging.
•
Before connecting the unit to the power source, let it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install handles.
•
This appliance is designed for free standing or built-in (fully recessed) installation.
•
Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded. To level the
appliance, adjust the front leveling leg at the bottom of the unit.
•
When moving your Wine and Beverage Center, please do not incline it more than 45 degrees.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption.
•
The beverage center should be placed in an area where the ambient temperature is less than 90 degrees
Fahrenheit and higher than the lowest temperature you want to store your beverages at. If the ambient
temperature is lower than the set temperature, the internal temperature will match the ambient temperature.
•
Avoid locating the unit in damp areas.
•
Plug the appliance into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or electrical grounding should be directed to a certified electrician or authorized products service center.
•
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 to 4 hours before placing wine
bottles in the appliance.
Handle Installation
Step 1: Remove the box containing the handle and screws from the Wine and Beverage Center.
Step 2: Pull out a bit of the rubber gasket from the back side of the holes.
Step 3: Insert the screws through the holes and connect with the handle.