Cyclone 50 2011
Page 2 of 3
©
Allseasons Hire
GENERAL SAFETY
o
Never place anything on top of the unit and never obstruct its air inlet/outlet grills.
Leave a 300 mm gap all round the unit to let the air circulate.
o
Always switch OFF and unplug the equipment when not in use.
ELECTRICAL SAFETY
o
This fan unit plugs into either a standard 230v 13 amp or a 110v power supply,
depending on model (see Data plate for voltage type). The plug (230v models only) is
fitted with a 13 Amp fuse.
o
Extension leads should be; correctly rated for the inductive load, fully unwound,
loosely coiled and never run through water or over sharp edges
o
To reduce the risk of electric shock, use a suitable RCD (residual current device)
o
Never pull the equipment by its flex
o
Ensure the unit and power socket are both switched OFF before plugging into the
power supply.
Set up and operation
o
Set the unit up on a firm, level surface and do not site the unit close to any personnel
wearing contact lenses, sensitive to any dust movement, hay-fever sufferers etc. This
unit moves air only, but minute particles of dust/pollen etc will also be moved,
especially on highest fan setting, so careful location/fan angle/use of speed control will
require consideration
o
The body of the fan is held in position via the side-mounted hand-wheels. To adjust,
slacken the wheels to allow the fan body to be moved. Once the desired angle is
reached, ensure the hand-wheels are turned hand tight to prevent movement
o
The air-flow from the fan exits from the side with the speed controller on it (the front),
the intake side is opposite
o
Plug the unit into the relevant power supply and switch the supply ON
o
Press the red ‘rocker’ switch, on the front of the unit to ON, which will then illuminate
o
Te fan blade should immediately start to turn & the speed can be controlled with the
knob on the control panel, turning CLOCKWISE TO INCREASE, ANTI-CLOCKWISE TO
DECREASE
o
Do not force the knob past the stop point; you will damage the speed controller.
Usage and care and storage
o
Never use an air mover except for its intended purpose
o
Keep the equipment clean & especially the grill faces
o
Blow out the grills with compressed air if ‘clogged’ up
o
Never move the unit whilst it is operating!
o
Switch the unit OFF and unplug from its power supply, wrap the cable round the
storage ears.
