Ÿ
Always disconnect any electrical devices when not in use.
Ÿ
Carefully examine your filter after installation. Do not connect the unit to the
mains if there is water on any parts not intended to be wet.
Ÿ
Before operating the pond pump observe that water is flowing through it -
the UV requires constant flow to avoid overheating.
Ÿ
To avoid injury, do not touch any moving or hot parts.
ELECTRIC
This unit comes complete with a generous supply of 3 core cable, however
should any additional cable be required, the use of an approved waterproof
cable connector with a proper rating is essential. A cord rated for less amperes or
watts than the appliance rating may overheat.
Please Ensure:
·
The power supply must be earthed and fused at 3amps.
·
You regularly inspect the cable for damage and deterioration.
·
Do not connect to any voltage other than that stated.
·
A residential current device (RCD) is used for additional safety
·
You have complied with Local Electricity Authority regulations if permanently
installing to the mains supply.
Please Ensure:
The power supply must be earthed and fused at 3amps.
Regularly inspect the cable for damage and deterioration. Consult a qualified
electrician if in doubt about any aspects of wiring.
OPERATION GUIDE
IMPORTANT
- Do not plug in the pump before it is correctly and fully installed.
Connect inlet / outlet to filter system or water feature if desired. Connect a
flexible hose (not included) to the hosetail provided. If necessary, cut the
hosetail at the required size by using a small hack saw to allow the hose to fit
correctly.
Securely position the pump on a raised, flat and stable surface in your pond
ensuring it is fully submerged.
Connect unit to the power supply.
