45
9. Remote Control Operation
[Entering a frequency directly]
Frequencies can be entered directly by pressing the numerical (1~0) keys.
Only valid numbers will be accepted and entered to the display.
1.
Set the microphone REMOTE / DTMF switch to the REMOTE position.
2.
DTMF keys can be used to enter ftom the 100 MHz digit.
(Ex.) When setting 144.20 MHz with the tuning step set to 5 kHz.
Enter
After entering the sixth digit a slightly longer beep is emitted and the entry is com-
plete.
3.
Cancelling an entry before it is completed. Press PTT, or any key other than the
numerical keys.
[Entry method depending on tuning step]
Depending on the set tuning step, digit entry may be necessary to the 1 kHz digit. In some cases
entry to the 10 kHz digit is sufficient. For cases in which digit entry is only necessary to the 10 kHz
digit some digit keys wre not accepted.
The relationshop between the tuning step and input method is as follows.
Tuning step
Entry
Final digit selection
completion digit
5.0 kHz
1 kHz
Completion after input of the 1 kHz digit.
8.33 kHz
10.0 kHz
10 kHz
Completion after input of the 10 kHz digit.
When you input the 10 kHz digit, the 1 kHz digit set as follows.
12.5 kHz
10 kHz
0···00.0, 1···12.5, 2···25.0, 3···37.5, 4···invalid
5···50.0, 6···62.5, 7···75.0, 8···87.5, 9···invalid
15.0 kHz
10 kHz
Completion after input of the 10 kHz digit.
20.0 kHz
10 kHz
Completion after input of the 10 kHz digit.
When you input the 10 kHz digit, the 1 kHz digit set as follows.
25 kHz
10 kHz
0···00.0, 2···25.0, 5···50.0, 7···75.0,
Other entries are invalid.
30 kHz
10 kHz
When you input the 10 kHz digit, the 1 kHz digit set as follows.
50 kHz
10 kHz
When you input the 10 kHz digit, the 1 kHz digit set as follows.
0···00.0, 5···50.0
