8
BASIC OPERATION
9
BASIC OPERATION
Receiving
When a signal is being received, the LED turns blue and hear the call.
Transmitting
Observe that the channel is not in use (Blue LED is not lit). Press and hold [PTT] key and talk to
microphone. While transmitting, the LED turns red. Please keep the distance between mouth and
speaker to be 2.5-5cm, speak in normal tone to get the best acoustic fidelity. Release the PTT to stop
transmitting. The red LED turns off.
4) TRANSMITTING AND RECEIVING
Press and hold P-key until it turns on with a beep sound. The battery level is displayed in 5 levels; 5 is
full, 1 is low and needs to be recharged. Release when the channel number is displayed. To Turn off,
press and hold P-key again. The radio needs to be turned on to operate following instructions.
1) TURN THE RADIO ON/OFF
Press P-key. The channel number starts to blink. Press
▲
(upward) /
▼
(Downward) keys to select a
desired channel. Pressing and holding ▲/▼ keys while selecting channels will continuously change
numbers. Please refer to P. 17 for DJ-PN446's default channel setting. Leave it for 5 seconds, or
press either PTT or P- key to set the selected channel.
3) CHANNEL SETTING
Press ▲/▼keys to display UL(Volume Level) and a volume level. Press either keys to increase or
decrease. The level is selectable from 0 to 8 (max) and press PTT or P-key to set.
You may feel a static shock when wearing a microphone in a dry atmosphere but it's not a defect of
product but a cause of nature. It is the same shock you feel typically when opening a door of a car in
certain conditions.
2) ADJUSTING VOLUME LEVEL
If there is blank channel between two channels, radio will skip blank channels.
If input channel number is not belong to programmed channel, radio will emit wrong prompt voice to
return current channel.
Channels not being programmed by the dealer software won' t be displayed. If it displays only "21"
and "23" skipping "22" , it means the ch. 22 has not been programmed by dealer.
