Alienware P150G, Руководство по обслуживанию

Страница: 41 / 73

3. Align the screw holes on the display assembly with the screw holes on the palm-rest and keyboard assembly.
4. Replace the six screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly and ensure that the
display is fully closed.
NOTE: If the display assembly is not fully closed, you will not be able to install the display-cable holder correctly.
5. Align and place the display cable holder with the triangle mark facing up and the display cable pointing towards the end of the
display cable holder with the triangle.
6. From the bottom of the display-cable holder, insert the display cable into the opening adjacent to the triangle mark and route the
display cable over the bar on the display-cable holder and into the opening on the other side of the display-cable holder.
7. Slide the display-cable holder back towards the display assembly until the triangle mark on the display cable aligns with the
triangle on the display-cable holder.
8. Rotate the display-cable holder to 180 degrees so that the "SNR" mark is facing up and the dotted line on the display cable is
within the space between the crossbar and the screw hole.
NOTE: If the dotted line is not aligned properly, flip the display-cable holder back over and adjust its position so that the
triangles are properly aligned.
9. Place the display cable holder on the slot on the palm-rest and keyboard assembly.
10. Replace the four screws (M2.5x5) that secure the display cable holder to the palm-rest and keyboard assembly.
11. Turn the computer over.
12. Connect the display cable to the system board.
13. Align and place the display-cable bracket on the system board.
14. Replace the two screws (M1.6x1.8) that secure the display-cable bracket to the system board.
Next steps
1. Install the
rear I/O-cover .
2. Install the base cover .
3. Follow the procedure in After working inside your computer .
System board
Removing the system board
Prerequisites
1. Follow the procedure in
Before working inside your computer .
2. Remove the base cover .
3. Remove the battery .
4. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive , as applicable.
5. Remove the wireless card .
6. Remove the rear I/O-cover .
About this task
NOTE: When removing this component, please refer to the techsheet bundled with the service kit. This is only applicable for
computers with the following Graphics Processing Unit (GPU) configurations that have Element 31 grease is applied to the CPU.
● NVIDIA GeForce RTX 3060
The following image indicates the connectors on your system board.
41