33
Version 1.01
The tool cannot perform the reading
and / or writing
Make sure that the red LED on the left side
of the tool is lit. If it is not lit, please
contact the Technical Support Service to
arrange the return of the tool for repair.
Make sure of using the correct cable
between KESSv2 and vehicle or ECU.
Make sure that this cable is properly
connected.
Make sure that this cable is not damaged.
Make sure you provided the power to the
ECU.
Make sure you have selected the correct
Family for the vehicle or the ECU to be
programmed.
Make sure that the green LED on the left
side of the tool is lit while attempting to
communicate with the vehicle and / or the
ECU.
If the problem persists, contact the Technical
Support Service providing the error code
displayed and a detailed description of the
operations performed.
Error messages: "Checksum error" or
"Correction Checksum Error "
Reinstall the K-Suite software, making sure
to confirm the installation of Microsoft
Visual C + + (see section
Installing the
software K-Suite - page
13
)
If the problem persists, send the file read from
the vehicle and the LOG file to the Technical
Support Service.
Error message: "Micro protection type
not supported. It's impossible to work
on this ECU"
You are trying to communicate with An
ECU equipped with a protected
microprocessor. Use one of the Families
dedicated to these types of ECUs,
identifiable by the initials “TPROT” in the
name.
Error message: "ECU not identified"
Send the file read from the vehicle and the
LOG file to the Technical Support Service to
have them check the original file and
possibly enable the recognition of the ECU.
