CHAPTER
2 R
EADER
H
ARDWARE
I
NSTALLATION AND
O
PERATION
ALR-9900
H
ARDWARE
S
ETUP
G
UIDE
DOC.
CONTROL
#8102086-000
REV
A
13
---------------------------------------------
Network Settings:
MAC Address : 00:80:66:10:2D:12
DHCP : 1
IP Address : 10.9.8.10
Netmask : 255.255.255.0
Gateway : 10.9.8.2
DNS : 10.9.8.1
TimeServer : time-a.timefreq.bldrdoc.gov
TimeZone : -7
---------------------------------------------
Once the reader boots and you see the "Boot>Ready!" prompt, pressing
return will bring up the "Alien>" prompt.
10. Ensure the PC has compatible network settings.
In order for you to be able to connect to the reader over TCP/IP, the host
PC must be on the same subnet as the reader. If you are unfamiliar with
how to do this, consult your local IT service for assistance.
Once the initial connection is made, you may configure your reader's
network settings as you choose. Refer to the
Reader Interface Guide
for
instructions on how to do this.
You are now ready to bench test or demonstrate the RFID Reader system.
Bench Test Procedure
1. Access an operational mode suitable for bench testing.
Select a mode that will allow multiple consecutive reads of a single tag,
such as Global Scroll if using the Alien Gateway software.
Refer to the applicable software application user guide for specific
instructions.
2. Position the reader so you can see the diagnostic LEDs.
You may also want to position the PC so you can view the monitor
simultaneously for later tests.
3. Move a tag slowly away from the antenna’s range.
Begin with the tag well inside the expected read range (~2m or 6 ft) and
move it toward the antenna while observing the LEDs.
4. Verify the SNIFF LED illuminates when the tag approaches the read
window.
SNIFF should be illuminated green.
5. Verify the READ LED illuminates when the tag is inside the read
window.
READ should be illuminated green.
