4
www.observint.com
© 2016, 2017 Observint Technologies. All rights reserved.
Mounting base
Mounting base cover
Tilt-mount
bracket
extension
2.
Attach the mounting base securely to the ceiling using two screws as needed. Screws and other
hardware items provided are adequate for mounting surfaces, but more appropriate fasteners may
be required.
Mounting base
3.
Position the mounting base cover over the base, and then reattach the tilt-mount bracket extension.
4.
Attach the sleeve to the camera sensor as shown in the drawing below. Install the screw (provided)
to secure the camera to the sleeve. The
TOP
label on the camera must be up.
Sleeve
Screw (provided)
ALI-NZ6032M camera sensor
TOP (label)
5.
Screw the sleeve with the camera onto the tilt-mount bracket as shown below.
Lock
nut
Knob
6.
Loosen the knob, and then aim the camera at your surveillance target. Tighten the knob and lock nut
to hold the camera in position.
7.
Plug the camera cable into the
VIN1
connector of the ALI-NZ60 module.
ALI-NZ6042HS Add-on Camera Installation
ALI-NZ6042HS add-on camera includes the following:
•
1080P WDR 3.7 mm Right Angle Pinhole camera
•
Upper and lower end caps for height strip
•
Camera mounting bracket
•
Mounting screws
Upper, lower
end caps
Height Strip
Right Angle
Pinhole camera
Camera bracket
front and back
To install this camera:
1.
Install the camera in the back of the camera bracket as shown below. The camera will snap into
place. Route the camera drop cable through the cable channel.
Cable
channel
2.
Slide the plastic measuring guide out of the Height Strip.
Measuring guide
3.
Anchor the Height Strip frame vertically at the preferred location. The mark inside the frame should
be 6 feet (1.83 m) above the floor. Use two screws, one at the top and one at the bottom. Screws
and other hardware items provided are adequate for mounting surfaces, but more appropriate
fasteners may be required.
Holes for
routing the
camera
drop cable
through the
surface
Height
strip
frame
